Wednesday, April 30, 2014


Written by Ken Jorgustin of Modern Survival Blog

Food Safe Plastics
Plastics that come in contact with your food or drink ‘should’ be safe based on the following general information. Look for the Recycle symbol (often on the bottom of the container) and read the number located inside the symbol.
The following list cross-references the recycle number (recycling symbol) with what is generally considered safe for food (or not safe).
Plastics Generally Considered Safe for Food and Drink
  • #2 HDPE  (high density polyethylene). See also discussion on food-grade buckets below.
  • #4 LDPE  (low density polyethylene)
  • #5 PP  (polypropylene)

Plastic Water Bottle or Soft Drink Container

  • #1 PETE (polyethylene terephthalate) typical water, soda, and juice bottles, not designed for reuse or storage due to the possibility of bacterial buildup, be sure to properly clean them if reusing. Varying reports regarding the possibility of BPA leaching over time.

Risky Plastics Not Safe for Food and Drink

These may leach or have hazardous ingredients.
  • #3 PVC  (polyvinyl chloride) carcinogens during manufacture and incineration
  • #6 PS  (polystyrene) possible carcinogen
  • #7 other  (usually polycarbonate, sometimes labeled PC)  may leach BPA (Bisphenol-A)

Food Grade Buckets

5-gallon ‘food grade’ buckets are made of #2 HDPE, and are opaque or mostly opaque which minimizes the amount of light penetration. If the bucket is considered food grade it is typically marketed as such and labeled “Food-Grade”, “Food Safe”, etc. Some food-grade buckets or containers will include a cup-and-fork symbol as an indicator. A food-grade bucket or container might also be specifically marked as USDA, FDA or NSF approved.
The typical blue water storage containers or water barrels are also made of high density polyethylene (#2 HDPE) and are marketed as food safe.
If you will be storing food directly in a plastic bucket or container, or if you will be using the container for drinking water, you might verify the material is food-safe before you purchase.
All food grade buckets are made of HDPE #2 (high density polyethylene), but not all HDPE #2 buckets are food-grade. Buckets that are not food-grade may out-gas and leach into the container, as well as into the contents placed within the container. 
HDPE #2 buckets that are not food-grade may have been manufactured with a non-food-grade “mold release agent”. In some processes, a mold release agent is what is used to help get the newly shaped plastic off of the hard mold that it was shaped from during the manufacturing process. Without the release agent, the new plastic shape will likely stick to the mold. Some mold release agents enable much faster production than others, but may be toxic to your health if later used with food.
Other processes apparently do not use a mold release agent and only use high pressure compressed air to blow the bottles into shape on the inside. No mold release agent of any kind is used inside the bottles of this process.
If you are unsure, you might simply contact the supplier or manufacturer to confirm.

No comments: